1 After the product is installed, add the hydraulic oil as required
above, start the engine, and
remember not to turn the direction in a hurry, first idle for tens
of seconds, then lightly press
the accelerator, slowly accelerate to 2000 rpm, and then lower to
idle speed, repeatedly work
for several times, lasting for 2 minutes, left and right, and
finally turn the steering wheel left and
right (remember not to beat the direction, otherwise it is easy to
damage the booster pump )
Exhaust the air in the steering system until there is no bubble and
the abnormal sound due to
air entering the pump disappears.
2 During commissioning, observe whether the oil of the power
steering pump is sufficient. If not, add it.
3 During commissioning,pay attention to observe whether there is
leakage in the steering system, and discharge it in time if any.
4 During commissioning, pay attention not to beat the direction,
including daily use. Otherwise, it is very easy to damage the
internal parts of the booster pump, causing excessive wear and
failure of the product and affecting the service life of the
product.
5 The noise may be produced during the initial installation of the
product. The main reason maybe the air entering. It is necessary to
run in several times to exhaust the air in the booster pump. If the
original hydraulic oil has dirt or the filter element is blocked,
it will also cause noise. Please change the hydraulic oil and
filter element first. After running in several times, check the
booster oil in the booster pump oil pot again to see if there is
any loss, if so, add it. For other faults, please refer to "common
faults and troubleshooting" in the manual.
6 The newly installed power steering pump shall not work at full
load immediately, and shall be operated at no load for a period of
time, so as to check the running in condition of the power steering
pump and exhaust the incoming air.
